Connecting a VP-128H Matrix Switcher
7
5 Connecting a VP-128H Matrix Switcher You can control the VP-128H via:
Its front (local) panel, see section 5.1
RS-232. For example, by connecting a PC via the null-modem adapter
(when using the Kramer Control software or other controller) if control via
RS-232 is required (see section 5.2)
10 Base T network (see section 5.3)
The RC-1616 Remote Control (see section 6)
5.1 Connecting the VP-128H Matrix Switcher
This section describes how to connect the VP-128H.
To connect your VP-128H Matrix Switcher
1
, connect the following
2
:
1. Connect up to 12 VGA/UXGA sources to the 12 HD15F input
connectors. For example
1
, connect a computer graphics source to the
INPUT 1 HD15F connector, and a laptop graphics source to the INPUT
12 HD15F connector.
2. Connect up to 8 HD15F output connectors to up to
3
8 VGA/UXGA
acceptors. For example
1
, connect the OUTPUT 1 HD15F connector to the
VGA/UXGA acceptor 1, for example, a projector, and connect the
OUTPUT 8 HD15F connector to the VGA/UXGA acceptor 8, for
example, a display.
3. Connect the Sync reference BNC connectors (optional).
4. Connect a PC (if required) to the RS-232 port, see section 5.2.
5. Connect the 10 Base T network port (if required), see section 5.3.
6. Connect the power cord
4
.
1 As the example in Figure 6 illustrates
2 Switch OFF the power on each device before connecting it to your VP-128H. After connecting your VP-128H, switch on its
power and then switch on the power on each device
3 When less than 8 outputs are required, connect only those outputs of the VP-128H and leave the other outputs unconnected
4 We recommend that you use only the power cord that is supplied with this machine