Kramer Electronics VP-1608 5.1 Connecting a Balanced/Unbalanced Stereo Audio Input/Output , 5.2 Connecting to the VP-1608 via RS-232 , 5.3 Connecting a PC or Controller to the RS-485 Port

VP-1608 - Connecting a Single VP-1608 11
5.1 Connecting a Balanced/Unbalanced Stereo Audio Input/Output
This section illustrates how to wire:
• A balanced stereo audio connection, see Figure 5
• An unbalanced stereo audio input connection, see Figure 6
• An unbalanced stereo audio output connection, see Figure 7
Figure 5: Balanced
Stereo Audio
Connection
Figure 6: Unbalanced
Stereo Audio Input
Connection
Figure 7: Unbalanced
Stereo Audio Output
Connection
5.2 Connecting to the VP-1608 via RS-232
You can connect to the VP-1608 via an RS-232 connection using, for example, a
PC. Note that a null-modem adapter/connection is not required.
To connect to the VP-1608 via RS-232:
• Connect the RS-232 9-pin D-sub rear panel port on the VP-1608 unit via a
9-wire straight cable (only pin 2 to pin 2, pin 3 to pin 3, and pin 5 to pin 5 need
to be connected) to the RS-232 9-pin D-sub port on your PC
5.3 Connecting a PC or Controller to the RS-485 Port
You can operate the VP-1608 via the RS-485 port from a distance of up to 1200m
(3900ft) using any device equipped with an RS-485 port (for example, a PC). For
successful communication, you must set the RS-485 machine number and bus
termination.