Krown Manufacturing manual Using Your Krown 200 with Wireless Phone

USING YOUR KROWN 200 WITH WIRELESS PHONE (CONT.)

USING YOUR KROWN 200 WITH A CORDLESS PHONE

You can connect your TDD to a cordless phone with a 2.5mm headset jack, and enjoy the

freedom of making a call around the house. Charge the cordless phone and TDD at night to get them ready to use next day.

Making a cordless phone call with your TDD.

1.Connect the TDD to the cordless phone using the 2.5mm audible cable.

2.Turn on your TDD

3.Press ON or TALK button on your cordless phone and watch “Phone” light on your TDD to

make sure you get a dial tone.

4.Dial number on your cordless phone.

5.If the other TDD or Relay agent picks up your call, your TDD will display text message and the communication link has begun.

TROUBLESHOOTING FOR TDD-WIRELESS CALL

There are many new technology that has been used to establish the wireless communication link between you and the other TDD users, you will get some problems sometimes by many causes.

Garbled Text: It may be caused by lost, damaged or late signals sending through the air to the receiver. It happens with any wireless call, even non-TDD calls, and mainly caused by nature. Move your TDD and wireless phone to where you can receive a strong and contact signal. If you use a cordless phone refer to your owner’s manual to know how to switch channel or move closer to the base to strengthen the signal. Always check to make sure you have a good connection from the cable to the TDD and the wireless phone.

“Drop Call”: This happens sometimes when you are moving between 2 call towers or in valleys, hills, and tunnels. Try to redial when you have a stronger signal from your

cell phone.

Feedback: If you see your “Phone” light on your TDD on constantly, your TDD is getting feedback. You may reduce the volume of your cell phone or cordless phone down until the red light turns off and then increase it for better receiving.

27