Kyocera KM-1820 E-mail Setting, Description, Host Name, IP Address, Subnet Mask, Dhcp/Bootp, Rarp

Setup

	The table below lists the settings displayed on the TCP/IP General Settings page.
Item	Description
Host Name	Specifies a name for the machine system network component. This name is also
	used as the NetBEUI Printer Name and the SNMP sysName object.
IP Address	Assigns the Internet Protocol address on the machine system network
	component. The format of the IP Address is four-byte (32-bit) numbers separated
	by dots, e.g. 192.168.48.21.
Subnet Mask	Specifies the subnet mask configured on the machine system network
	component. If the machine system does not automatically assign a usable
	default value and the first number in the IP address is from 192 to 254, then use
	255.255.255.0 as the subnet mask.
Default Gateway	The IP address of the gateway router for the local network.
DHCP/BOOTP	Identifies how the machine obtains its IP configuration: DHCP/BOOTP: automatic
	configuration via a BOOTP server or a DHCP server.
RARP	Automatic configuration using the Reverse Address Resolution Protocol.
DNS Server (Primary,	The IP address of the primary and secondary Domain Name System (DNS)
Secondary)	servers.
Domain Name	The Domain Name System (DNS) to which the machine system belongs, such as
	abcdnet.com. It should not include the host machine name.
WINS Server (Primary,	The IP address of the primary and secondary Windows Internet Name Service
Secondary)	(WINS) servers.
Scope ID	This section determines the scope of IP addresses that a Windows server can
	grant or lease to any requesting network component. A DHCP server processes
	the machine system’s discovery broadcasts and returns an IP address to it. The
	DHCP server may be set up to grant an IP address for a limited time (a
	temporary lease) or for an unlimited time (an unlimited lease), or it may be
	configured with a permanent address reservation for the machine system.
FTP Status Check	Enables or disables the FTP Status Check.

E-mail Setting

The following procedure explains the method for attaching scanned data to an e-mail for transmission.

Scan to e-mail works within the following environments:

• It must have a network environment in which this machine can connect to a mail server. It is recommended that the machine be used in an environment in which it can connect to the mail server at any time over a LAN.

• The SMTP settings must be completed. Use COMMAND CENTER to register the IP address and the host name of the SMTP server.

• There may be times when transmission is not possible due to the size of each e-mail item.

8 NETWORK SCANNER SETUP GUIDE