
LaCinema HD Connect
User Manual
Introduction
page 11
1.5.Views of the LaCinema HD Connect
1.5.1.Front View
1.Infrared receiver – Receives the infrared signal from the remote control. Make sure the receiver is not obstructed.
2.Blue status light – If the drive is connected to a TV or computer, this light will be on. It will turn off when disconnected.
3.USB port (connect disk) – Connect a USB disk, digital camera, or card reader to access its multimedia files directly from your TV.
1.5.2.Rear View
1.USB 2.0 host – Connect a USB disk, digital camera, or card reader
2.Ethernet connector – Connect to your home network via an Eth- ernet cable to your router
3.Optical audio out – Connect to digital home amplifier
4.Video composite + stereo connector – Connect to any TV (CRT)
5.HDMI – Connect to a High Definition flat screen TV or video projector
6.Power connector – Must be connected when the drive is at- tached to a TV. When connected to a computer, the drive is bus powered through the USB connection, but if your computer does not provide enough power through the USB port, connect the power supply.
CAUTION: Do not stack another electronic device on or below the LaCinema HD Connect or place it in an enclosed area to avoid performance and overheating issues (Fig. 06).
Fig. 04
Fig. 05
Fig. 06