LaCie Network Space user manual Turn the Drive On, Drive to the on position

LaCie Network Space • DESIGN BY NEIL POULTON	Setup
User Manual	page 9

2.1. Turn the Drive On

The power supply kit is composed of two cables: one cable (A) connects to the LaCie drive; and the other cable (B) connects to a power outlet, such as a wall outlet or a surge protector.

1. Connect Cable A to the LaCie Network Space.

2. Connect Cable B to the power supply brick (C).

3. Connect Cable B to a surge protector or wall outlet.

4. Turn on the drive by moving the power switch on the back of			B
	the drive to the “on” position.
The LaCie Network Space system may take up to 30 seconds to
boot up.
	CAUTION: Only use the AC adapter supplied with your spe-
				C
	cific LaCie device. Do not use a power supply from another
	LaCie device or another manufacturer. Using any other power
		A
	cable or power supply may cause damage to the device and
	void your warranty.

Always remove the AC adapter before transporting your LaCie drive. Failure to remove the adapter may result in damage to your drive and will void your warranty.

TECHNICAL NOTE: You may use your LaCie drive when in a foreign country thanks to its 100-240 Volt power supply. To be able to use this feature, you may need to purchase an appro- priate adapter or cord. LaCie accepts no responsibility for any damage to the drive resulting from the use of an inappropriate adapter. Using an adapter other than one authorized by LaCie will void your warranty.