Land Pride RCMB6015, RCMB6010 manual Hitch Assembly, Wing Axle Assembly, Hydraulic Plumbing

Table of Contents

Section 1: Preparation and Set-up

Land Pride

	1
3	1
	2
	23578

Hitch Assembly Illustration

Figure 1-2

Hitch Assembly

Refer to Figure 1-2:

NOTE: Do not tighten the hardware until assembly is complete.

1.Install left and right leveling rods (#1) to the hitch frame with 3/4” x 1 1/2” clevis pins, 3/4” flat washers, and 1/8” x 1 1/4” cotter pins. Final adjustment should be made when the cutter is attached to the tractor.

2.Install parking jack (#2) to the hitch frame and secure with attached pin (#3). Adjust parking jack to preferred drawbar height.

Wing Axle Assembly

NOTE: Do not tighten the hardware until assembly is complete.

Refer to Figure 1-3

Wing axle locknuts are tightened for shipping purposes.

1.Loosen lock nuts (#1) slightly and rotate wing axles (#2) to install turnbuckles (#3).

2.Remove cap screws and locknuts (#4). Attach turnbuckles (#3) to the wing axles with existing cap screws and lock nuts (#4).

Hydraulic Plumbing

The cutter is equipped with one hydraulic cylinder in the center for lifting the cutter and one on each wing for folding of the wings independently. All cylinders on the cutter are single action (one-way) type and should not be plumbed for two-way operation.

Each duplex outlet on your tractor can perform only one operation. One outlet is needed for lifting the cutter and a second and third for lifting the wings independently of each other.

If the tractor being used does not have the required number of duplex outlets, an optional control valve kit is available from your dealer.

Your Dealer will be able to help you determine the best configuration to match your needs and your tractor.

2

	1
	Turnbuckle (#3)
	to be secured
	between this
4	flange and the
	one below.

3

23703a

Wing Axle - Turnbuckle Assembly

Figure 1-3

12 RCB6010 & RCB6015 (540 RPM) and RCMB6010 & RCMB6015 (1000 RPM) Rotary Cutters 318-263M 9/04/08