Land Pride | Table of Contents |
Section 4: Maintenance & Lubrication
Oil Fill & Vent Plug
Oil Level Plug
| 24852 |
| Oil Fill Plug |
| Oil Level Plug |
23603 | Oil Drain Plug |
8
Hrs
Divider Box
Type of Lubrication: 80-90W EP
Quantity = As required
NOTE: Do not overfill! Cutter should be level when checking oil. If, for any reason, all oil has been removed from gearbox, refill to level plug and allow air to bleed up from lower cavity, then recheck.
23582 |
IMPORTANT: Your cutter is shipped with the gearbox vent plug with dipstick packaged in the Operator’s Manual bag and should have been installed in the gearbox by your Land Pride dealer. Please see your Land Pride dealer if the vent plug with dipstick was not included.
8
Hrs
Gearbox
IMPORTANT: Do not overfill! Level cutter and wait for gearbox oil to cool before checking. An unlevel cutter or a gearbox with hot oil will not show correct oil level on the dipstick.
Make sure wings are down. Unscrew top vent plug in gearbox to remove dipstick. Wipe excess oil from dipstick and screw it back into the plug hole. Remove dipstick again and check oil level mark on dipstick. If low, fill through top plug hole in gearbox with EP90 oil until oil reaches full mark on dipstick. Reinstall vent plug with dipstick and tighten.
Take your gearbox to a Land Pride dealer if it requires service.
Type of Lubrication: EP90 Oil
Quantity = Fill until oil reaches full mark on dipstick.
|
| 8 |
|
|
| Hrs |
|
| Intermediate Driveline Joints |
|
|
| Type of Lubrication: |
| |
| 23563 |
|
|
9/04/08 | RCB6010 & RCB6015 (540 RPM) and RCMB6010 & RCMB6015 (1000 RPM) Rotary Cutters | 31 | |
