Land Pride RCMB6015, RCMB6010 manual Unhooking From the Cutter

Table of Contents

Section 1: Preparation and Set-up

Unhooking From the Cutter

1.Park cutter on a level solid hard surface. Place tractor gear selector in park and set park brake.

2.Refer to “Transporting The Cutter”, Figure 2-1 & Figure 2-2on page 18. Raise wings up in the transport position and place transport lock bars in the locked position. Make sure transport bars are secured in place with lock pins (#2) and hair pins (#1).

3.Remove stroke control spacers from the center hydraulic cylinder and lower cutter until front skids are resting on the ground. Replace stroke control spacers as needed to support wheels at this position.

4.With tractor gear selector in park and park brake set, shut tractor engine off, and remove switch key. Move cylinder lift levers back and forth to release hydraulic line pressure.

5.Refer to “Hitch Assembly Illustration” (Figure 1-2) on page 12. Remove the parking jack (#3) from the left hand wing deck or weight box and install to cutter hitch. Secure the parking jack in place with attached jack pin (#4).

6.Adjust the parking jack as needed to remove the hitch pin.

7.Remove hitch pin and unhook hydraulic hoses from tractor. Store hose ends on cutter deck.

8.Lower the parking jack to rest cutter on its front skids.

Land Pride

16 RCB6010 & RCB6015 (540 RPM) and RCMB6010 & RCMB6015 (1000 RPM) Rotary Cutters 318-263M 9/04/08