Land Pride Z60 Assembly and Set-Up, Bagger Assembly Figure, Front Lift and Weight Assembly Figure

Land Pride

Section 1 Assembly and Set-Up

5.Install bagger (#1) through brackets and secure with pins (#2).

6.Assemble clamps (#3) on the ends of the bagger tube (#4) and slide the tube over the bagger inlet and the blower as shown in Figure 1-9 and tighten clamps.

NOTE: Lubricant can be used when installing tube to bagger so the tube will slide over bagger inlet easier.

Bagger Assembly

Figure 1-9

Front Lift and Weight Assembly (For Blade Service or Replacement)

IMPORTANT: Do not use jack to support mower while working under the deck. Chock back wheels and securely block unit up before working under the deck.

1. The front weight bracket (#1) will mount to the front of the mower frame with the four u-bolts (#2) lock washers (#3) and nuts (#4) on the Z60 & Z72 mowers. The Z52 mounts with two u-bolts (#2) on the right side and one bolt (#7) and nut (#4) on the left side of frame as shown in Figure 1-10.

2. Fill the weight (#5) with sand and secure to weight bracket with bolts (#8), lock washers (#9) and flat washers (#10).

3. Assemble jack (#6) to the jack mount on the weight bracket.

Front Lift and Weight Assembly

Figure 1-10

19911

Z52 Left Side

19909

12 Z52®, Z60® & Z72® Zero Turning Radius Mowers Accu-Z 356-005M 03/11/03