Land Pride Z52 Stop Handle, Height Adjusting Stop, Blocks, Deck Lift threaded Rod Nut Nut Chain

Land Pride

Section 3 Adjustments

Deck Level Adjustments

Leveling the deck must be done in the following manner and order:

1.Check tire pressures to make certain they are properly inflated before starting to level deck. See “Tire Inflation Chart” page 44.

!WARNING!

Stop engine. Make sure deck clutch switch is in the down (OFF) position. Place control levers in the brake position before leaving machine.

2.Park the unit on a flat surface.

3.Raise deck and place 3" of blocking under all 4 corners of the deck. This will set the cutting height at 3“. Refer to Figure 3-14.

NOTE: Back of deck will automatically be set 1/4" higher.

Stop

Handle

Height Adjusting

Stop

Blocks

Blocking up Deck	19088
Figure 3-14

4.Set cutting height at 3" on the height indicator by placing the height adjusting stop in the 3" hole, and turning the height stop so that the flat side is against the stop handle. Refer to Figure Figure 3-15.

Cutting Height	19089
Figure 3-15

5.Clamp the height adjusting stop against the stop handle (Figure 3-15). This will assure that the height will not move during the setting process. Otherwise, spring pressure from the deck lift springs will tend to pull the stop away from the handle.

6.Refer to Figure 3-16, Figure 3-17& Figure 3-18.Loosen all nuts on the deck lift threaded rods, and the hardware on the adjuster (on the right front), until all the deck lift chains are loose, and the deck is sitting tightly on all four blocks.

Deck Lift

threaded Rod

NutNut

Chain

Deck Level Adjustment	19090
Figure 3-16

26 Z52®, Z60® & Z72® Zero Turning Radius Mowers Accu-Z 356-005M 03/11/03