Land Pride
Important Safety Information
These are common practices that may or may not be applicable to the products described in this manual.
Prepare for Emergencies
▲Be prepared if a fire starts.
▲Keep a first aid kit and fire extinguisher handy.
▲Keep emergency numbers for doctor, ambulance, hospital and fire department near phone.
Wear
Protective Equipment
▲Protective clothing and equipment should be worn.
▲Wear clothing and equipment appropriate for the job. Avoid loose fitting clothing.
▲Prolonged exposure to loud noise can cause hearing impairment or hearing loss. Wear suitable hearing protection such as earmuffs or earplugs.
▲Operating equipment safely requires the full attention of the operator. Avoid wearing radio headphones while operating machinery.
Avoid High
Pressure Fluids Hazard
▲Escaping fluid under pressure can penetrate the skin causing serious injury.
▲Avoid the hazard by relieving pressure before disconnecting hydraulic lines.
▲Use a piece of paper or cardboard, NOT BODY PARTS, to check for suspected leaks.
▲Wear protective gloves and safety glasses or goggles when working with hydraulic systems.
▲If an accident occurs, see a doctor immediately. Any fluid injected into the skin must be surgically removed within a few hours or gangrene may result.
911
Safety Labels
1.Your mower comes equipped with all safety labels in place. They were designed to help you safely operate your mower. Read and follow their directions.
2.Keep all safety labels clean and legible.
3.Replace all damaged or missing labels. To order new labels go to your Land Pride dealer.
4.Some new equipment installed during repair require safety labels to be affixed to the replaced component as specified by Land Pride. When ordering new components make sure
the correct safety labels are included in the request. To order new labels go to your Land Pride dealer.
5.Refer to this section for proper label placement. To install new labels:
a.Clean the area the label is to be placed.
b.Spray soapy water on the surface where the label is to be placed.
c.Peel backing from label. Press firmly onto the surface.
d.Squeeze out air bubbles with the edge of a credit card.
03/11/03 | Z52®, Z60® & Z72® Zero Turning Radius Mowers | 3 |
