Land Pride Z60 Front Brake Link Right Side, Control Lever Park Brake Slot Outside Edge, Jam Nut

Land Pride

Section 3 Adjustments

Front Brake Link

(Right Side)

Front Brake Link	19083
Figure 3-7

2.Raise and block the mower up so the drive wheels are off of the floor.

3.Open the hydraulic pump’s bypass valve (Refer to Figure 3-8)on the side that is being adjusted, by turning bypass valve counter clockwise one-half to one revolution. The valve stems on each hydraulic pump are located near the top and are identified as a hex stud.

4.Rotate the tire. The tire should rotate. Remember hydraulic oil resistance will prevent the tire from rotating freely even with the bypass valves open. There should be no resistance from the brakes at this point.

5.Move the control lever to where it is touching the outside edge of the lever’s travel slot.

Refer to Figure 3-9.

Control Lever

Park Brake Slot

Outside Edge

Travel Slot

Control Lever Touching Edge	19084
Figure 3-9

6.Rotate the tire. If the brake is adjusted properly the tire will still rotate but friction will start to become noticeable here. However, if no brake resistance is noticed, the brake needs adjusted as follows:

7.Loosen the brake linkage jam nuts. Refer to Figure 3-10.

By-Pass Valve

Jam Nut

Jam Nut

By-Pass Valve

Figure 3-8

Brake Linkage Turnbuckle

Loosen Brake Linkage Jam Nut	19085
Figure 3-10

24 Z52®, Z60® & Z72® Zero Turning Radius Mowers Accu-Z 356-005M 03/11/03