Land Pride Z52 , Z60, Z72 manual Control Lever and Seat Assembly, Remote Air Cleaner Assembly

Land Pride

Section 1 Assembly and Set-Up

Control Lever and Seat Assembly

The seat is removed for ease in shipping and the control lever’s upper bolts and flat washers are removed and the levers are rotated down.

Refer to Figure 1-1:

1.Install the standard seat (#1) (or the optional suspension seat) to the seat pan (#2) using four 5/16” nuts (#3) and four 5/16” flat washers (#4).

2.Connect the switch wires on the mower with the switch wires on the seat. Secure the switch wires to the seat pan (#2) using three wire ties (#5).

3.Flip the seat over into the operating position and rotate the control levers up until the holes line up and replace the bolts and flat washers.

20858

Remote Air Cleaner Assembly

Refer to Figure 1-2:

1.Slide air cleaner clamp (#1) over air cleaner housing (#2), position the clamp so the bolt holes are facing down (away from the intake) and the notches on the clamp fit in the notches on the housing.

2.Insert air cleaner element (#3) inside air cleaner housing (#2) and attach housing end (#4) (with the arrows pointing up). Place rubber grommet (#5) over opening in housing end (#4).

3.Attach air cleaner intake cap (#6) to the air cleaner housing (#2) using a hose clamp (#7).

4.Attach air cleaner hose (#8) to the air cleaner (#2) using a hose clamp (#7).

Seat Assembly

Figure 1-1

20862

Refer To Figure 1-3:

5. Remove plastic cap from carburetor intake.

!CAUTION!

Be careful to not allow any foreign material into the carburetor while performing this assembly.

Air Cleaner Assembly

Figure 1-2

Plastic Cap

20859

Carburetor Intake

Figure 1-3

03/11/03 Z52®, Z60® & Z72® Zero Turning Radius Mowers Accu-Z 356-005M 7