IMPORTANT SAFETY INFORMATION
THIS IS A HEATING APPLIANCE
DO NOT OPERATE THIS APPLIANCE WITHOUT FRONT PANEL INSTALLED.
• Due to high temperatures the appliance should be located |
| SERVICE PERSON. The appliance should be inspected | |
out of traffic and away from furniture and draperies. |
| before use and at least annually by a qualified service | |
• Children and adults should be alerted to the hazards of |
| person. More frequent cleaning may be required due to | |
| excessive lint from carpeting, bedding materials, etc. It | ||
high surface temperatures and should stay away to avoid |
| ||
| is imperative that control compartments, burners and | ||
burns or clothing ignition. |
| ||
| circulating air passageways of the appliance be kept | ||
• Young children should be carefully supervised when they |
| ||
| clean. | ||
are in the same room as the appliance. | • DO NOT put anything around the furnace that will | ||
• Clothing orotherflammable material should not be placed | |||
| obstruct the flow of combustion and ventilation air. | ||
on or near the appliance. | • | DO keep the appliance area clear and free from | |
• Any safety screen or guard removed for servicing an | |||
| combustible material, gasoline and other flammable | ||
appliance must be replaced prior to operating the |
| vapors and liquids. | |
appliance. | • DO examine venting system periodically and replace | ||
• Keep burner and control compartment clean. | |||
| damaged parts. | ||
• Vent cap hot while furnace is in operation. | • | DO make a periodic visual check of burner. Clean and | |
• For manufactured home (USA only) or mobile home or |
| replace damaged parts. | |
residential installation convertible for use with natural | • | DO NOT use this heater if any part has been under water. | |
gas and liquefied petroleum gases when provision is made |
| Immediately call a qualified service technician to inspect | |
for the simple conversion from one gas to the other. |
| the heater and to replace any part of the control system | |
• Installation and repair should be done by a QUALIFIED |
| and any gas control which has been under water. | |
|
|
|
Page 3 |