Lantronix 900-598 manual Command Mode, Line Command Description Mode Settings

7:Line and Tunnel Settings

Line Settings	Description
Baud Rate	Sets the Baud Rate (speed) of the Line. The default is 9600.
	Any set speed between 300 and 921600 may be selected: 300, 600, 1200, 2400,
	4800, 9600, 19200, 38400, 57600, 115200, 230400, 460800, 921600.	When
	selecting Custom baud rate (available for line 1 and line 2 only), you may manually
	enter any value between 300 and 5000000.
Parity	Sets the Parity of the Line. The default is None.
Data Bits	Sets the number of data bits for the Line. The default is 8.
Stop Bits	Sets the number of stop bits for the Line. The default is 1.
Flow Control	Sets the flow control for the Line. The default is None.
Xon Char	Set Xon Char to be used when Flow Control is set to Software. Prefix decimal with \
	or prefix hexadecimal with 0x or prefix a single control character <control>.
Xoff Char	Set Xoff Char to be used when Flow Control is set to Software. Prefix decimal with \
	or prefix hexadecimal with 0x or prefix a single control character <control>.
Gap Timer	Set the Gap Timer delay to Set the number of milliseconds to pass from the last
	character received before the driver forwards the received serial bytes. By default,
	the delay is four character periods at the current baud rate (minimum 1 ms).
Threshold	Set the number of threshold bytes which need to be received in order for the driver to
	forward received characters.

Command Mode

	Table 7-2 Line Command Mode Settings
Line Command	Description
Mode Settings
Mode	Sets the Command Mode state of the Line. When in Command Mode, a CLI session
	operates exclusively on the Line. Choices are:
	 Always
	 Use Serial String
	 Disabled
	Note: In order to enable command mode on the Line, Tunneling on the Line must be
	Disabled (both connect and accept modes).
Wait Time	Enter the amount of time to wait during boot time for the Serial String. This timer
	starts right after the Signon Message has been set on the Serial Line and applies only
	if mode is “Use Serial String”.

PremierWave XC User Guide 47