Programming Commands

To access the master clock’s programming functions, press [#] to enter program mode. When SELECT FUNCTION CODE appears on the display, the clock is ready for programming. The master clock will automatically exit out of program mode if you have not made a key pad entry for five minutes.

[0]=PASSWORD

A password is required for most programming functions. To enter either the administrative or user password, press [#][0][#], followed by the six-digit password, then press [#].

You can now program the master clock until the password expires. A password expires after approximately five minutes. If the master clock starts blocking access to programming functions, re-enter the password.

The administrative password 332537 [DEALER] enables you to access both user and advanced functions.

The default user password 000000 is used to access user functions. Use the [C]=CHANGE PASSWORD function to change your user password (see page 3-6). You cannot change the administrative password.

[1]=SET DATE / TIME

To set the date and time, see Setting the Date and Time on page 2-3.

[2]=SELECT CLOCK CTL

This function requires the administrative password. Use this function to choose the clock types that the master clock will synchronize.

See Choosing the Clock Types to Synchronize on page 2-5.

24A715/24A715M Master Clock Installation Manual

3-3