FCC RF Exposure Compliance Requirements - for Occupational Use Only
The Federal Communications Commission (FCC), with its action in General Docket 93-62, November 7, 1997, has adopted a safety standard for human exposure to Radio Frequency (RF) electromagnetic energy emitted by FCC regulated equipment. Topaz3 / Legacy subscribes to the same safety standard for the use of its products. Proper operation of this radio will result in user exposure far below the Occupational Safety and Health Act (OSHA) and Federal Communications Commission limits.
Antennas used for this transmitter must not exceed an antenna gain of 3 dBd. The radio must be used in vehicle-mount config-urations with a maximum operating duty factor not exceeding 50%, in typical push-to-talk configurations. This radio is NOT approved for use by the general population in an uncontrolled environment. This radio is restricted to occupational use, work related operations only where radio operator must have the knowledge to control the exposure conditions of its passengers and bystanders by maintaining the minimum separation distance of 5 feet (1.7 meters) between any persons and the antenna. Failure to observe these restrictions will result in exceeding the FCC RF exposure limits.
CAUTION - DO NOT transmit for more than 50% of total radio use time (50% duty cycle). Transmitting more than 50% of the time can cause FCC RF exposure compliance requirements to be exceeded. The radio is transmitting when the “TX” icon on the radio display is illuminated. You can cause the radio to transmit by pressing the P-T-T button on the radio’s microphone.
CAUTION - DO NOT operate the transmitter of ML3215, ML3245 mobile radios when someone (bystanders) outside the vehicle is within 5 feet (1.7 meters) of the antenna.
NOTE: This radio operates in FCC regulated frequency bands. All radios must be licensed by the FCC before use. Because this radio contains a transmitter, Federal law prohibits unauthorized use or adjustments of this radio.
This device complies with Part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference.
WARNING - Frequency band 406 - 406.1 MHz is reserved for use ONLY as a distress beacon by the US Coast Guard and NOAA. Under no circumstance should this frequency band be part of the pre- programmed operating frequencies of this radio.
Safety
CAUTION -
CAUTION - atmosphere.
CAUTION - All equipment must be properly grounded for safe operation.
WARNING - DO NOT allow children to operate transmitter - equipped radio equipment. WARNING - All equipment should be serviced by a qualified technician.
WARNING - It is mandatory that radio installations in vehicles fueled by liquefied petroleum gas conform to the following standard: National Fire Protection Association Standard NFPA 58 applies to radio installations in vehicles fueled by liquefied petroleum (LP) gas with LP gas container in the trunk or other sealed-off space within the interior of the vehicle. This standard requires that:
1.Any space containing radio equipment shall be isolated by a seal from the space in which the LP gas container and its fittings are located.
2.Remote (outside) filling connections shall be vented to the outside.
About Topaz3
Topaz3 is the exclusive supplier of Maxon, Legacy and TruTalk brand communication products. Our product line ranges from FCC licensed two-way radios suitable for Business and Industry (B&I) markets like farm, government, law enforcement, utility, etc. to consumer communications equipment for recreational and light-duty business markets.
Product offerings include a variety of UHF and VHF handheld and mobile radios, repeaters and RF link modules as well as GMRS (General Mobile Radio Service) radios, MURS (Multi User Radio Service) radios, Citizen’s Band radios and weather monitors.
Available accessory items include a variety of carrying cases, spare batteries, desktop and mobile chargers, ear bud speaker microphones and more for each radio model.
For additional information on our product line, visit our website: www.topaz3.com
About Your Legacy ProLine Radio
The Legacy ProLine models ML3215 (VHF) and ML3245 (UHF) are fully programmable, synthesized radios featuring:
32 Channels of operation | Busy channel lockout |
8-Character alphanumeric display | Programmable CTCSS / DCS tones and two-tone decode |
2 or 45 Watts output power | Wide / narrow channel spacing |
Channel scan | TX Inhibit |
38 Standard and 11 non-standard CTCSS tones | VOX operation |
104 DCS Codes | Public address mode |
Approved to MIL-STD810F specifications | Nuisance Delete |
Scan channel delete | Die-cast aluminum frame, polycarbonate cabinet |
Please read this manual thoroughly before operating the radio. Application of some functions described in this manual are determined by the system you use. Your radio communications Dealer will program your radio for you to have the greatest number of functions possible relative to your needs.
Should you have questions regarding the operation of this radio, consult your radio communications Dealer, or contact the Topaz3 Customer Service Department: 1-816-891-6320, Ext. 730.
Unpacking Information
Carefully unpack the radio and its accessories. Use the item list below to identify the components included in the product packaging, to ensure that no items are discarded in the packing materials.
Radio Body
Microphone
Mounting hardware
Mounting Bracket
Fused Power Cord
Operating Instructions
