Miscellaneous

Monitor/Viewfinder displays

[Failed to connect wireless access point] / [Connection failed] / [No destination found]

●●Check the following regarding the wireless access point.

→ The wireless access point information set on the camera is wrong. Check the authentication type, encryption type, and encryption key. (→193)

→ The power of the wireless access point is not turned on.

→ The setting of the wireless access point is not supported by the camera. ●●Check the network setting of the destination.

●●Radio transmission from other devices may block the connection to a wireless access point.

→Check other devices that are connected to the wireless access point and devices that use the 2.4GHz band.

[No picture to send]

●●This is displayed when there is no image to transmit due to the restriction of the destination. Check the file type of the image to transmit. (→185)

[Connection failed. Please retry in a few minutes.] / [Network disconnected. Transfer stopped.]

●●Radio transmission from the wireless access point are getting weak. → Perform the connection closer to the wireless access point.

●●There is no reply from the server or it has exceeded the communication processing time. → Try again after a while.

●●Depending on the wireless access point, connection may be automatically disconnected after specific time has passed.

→ Reconnect the connection again.

[Connection failed]

●●Check the following regarding the smartphones you intend to connect.

→The smartphone does not operate.

→Change the access point to connect to in the smartphone Wi-Fi settings to this camera.

→There is no free storage space on the smartphone.

[Some files cannot be sent because of destination limit] /

[Transfer completed. Some files are left because of destination limit.]

●●Check the file format of the image to send.

●●Sending motion pictures may fail if the file size is too large. Split the motion picture using [Video Divide]. (→161)

[Cannot get IP address. Please set wireless AP’s IP address setting to DHCP.]

●●Turn on DHCP settings of the IP address of the connected wireless access points.

[Cannot connect to server]

●●If a message is displaying asking to update the root certificate, agree to update the root certificate.

- 224 -