6. Optional accessories

6.3.3 Knife holder N/NZ

The knife holders N and NZ are appropriate for standard steel and tungsten carbide knives, profile c and d, up to 16 cm long. The integrated height adjustment feature allows you to also use knives that have been resharpened numerous times.

Mounting the knife support bar

Push knife guard (8) to the center.

Set the knife support bar (46) onto the height adjustment screws (not visible) in the position shown. The flat ends of the height adjustment screws must be located in the slots at each end of the knife support bar.

Prior to inserting the knife, both knife holder and knife holder base must have been installed on the instrument!

Enlarged detail: Knife inserted and

height-adjusted 49 39

Knife holder N

For holding conventional knives up to 16 cm in length.

Knife holder NZ

For holding conventional and hard metal knives up to 16 cm in length. Knife pressure plate (56) for extreme stability and full utilization of the knife blade.

8

47

56

49

48 46

Fig. 44

Leica RM2245

49

Page 49
Image 49
Leica RM2245 instruction manual Knife holder N/NZ