1.Carefully insert the TORX screwdriver provided into the cutout in the handle (see 1 in Figure 20).
2.Rotate the screwdriver in an
Note: Do not turn the lock more than half a turn; otherwise, the drive carrier may be damaged.
3.Remove the screwdriver.
Figure 20. Deactivating an
BIOS settings
To install the AMI StorTrends iTX software, verify the following BIOS settings:
1.Disable the Onboard SATA Controller option to install onto the boot drive. This option is present in the ATA Controller Configuration settings under the Advanced tab.
2.Enable the LSI MPT SAS Controller option, which is present in the Mass Storage Controller Configuration settings under the Advanced tab.
3.If you add DIMMS to increase system memory, the default BIOS option limits the memory visible to the operating system to 2.50GB. To make more memory visible to the operating system, modify the Memory Mapped I/O Start Address option, which is present in the PCI Configuration settings under the Advanced tab.
4.To boot from the network using PXE boot, enable the option Onboard NIC ROM option, which is also present in the PCI Configuration settings. The device boot order registers this change after you save the changes and reboot.
5.To boot from the boot drive attached to the LSI MPT SAS controller, change the hard disk order under the Boot Options tab. Set ID01 LUN0 as the first disk, followed by the PCI RAID adapter. If you need to enable the network boot, select IBA GE as the first boot device.
6.To boot from the boot drive attached to the LSI MPT SAS controller, set ID01 LUN0 as the second boot option under the Boot Options tab.
Note: The drives need to be connected to the blue SATA slots on the server board for installation.
Turning off
To turn off the enclosure, either:
vTurn off the PSU installed in the enclosure by pressing the power
OR
vRemove AC main at the power source
22User Guide
