LevelOne GSW-0890 user manual CLI Management, Login

4. CLI Management

4-1. Overview

Refer to Chapter 2 for basic installation. The following description is the brief of the network connection.

--Locate the correct DB-9 null modem cable with female DB-9 connector. Null modem cable comes with the management switch. Refer to the Appendix B for null modem cable configuration.

--Attach the DB-9 female connector to the male DB-9 serial port connector on the Management board.

--Attach the other end of the DB-9 cable to an ASCII terminal emulator or PC Com- 1, 2 port. For example, PC runs Microsoft Windows HyperTerminal utility.

--At “Com Port Properties” Menu, configure the parameters as below: (see the next

section)

Baud rate	57600
Stop bits	1
Data bits	8
Parity	N
Flow control	none

Login

The command-line interface (CLI) is a text-based interface. User can access the CLI through either a direct serial connection to the device or a Telnet session. The default values of the managed switch are listed below:

Username: admin

Password: admin

After you login successfully, the prompt will be shown as “#“ if you are the first login person and your authorization is administrator; otherwise it may show “$“. See the following two figures. The former means you behave as an administrator and have the access right of the system. As to the latter, it means you behave as a guest and are only allowed to view the system without the permission to do any setting for this switch.

137