Mode:
Set the speed and duplex of the port. In speed, if the media is 1Gbps fiber, it is always 1000Mbps and the duplex is full only. If the media is TP, the Speed/Duplex is comprised of the combination of speed mode, 10/100/1000Mbps, and duplex mode, full duplex and half duplex. The following table summarized the function the media supports.
Media type
NWay | Speed |
| Duplex |
1000M TP | ON/OFF | 10/100/1000M |
1000M Fiber | ON/OFF | 1000M |
Full for all, Half for 10/100 Full
In
Flow Control:
There are two modes to choose in flow control, including Enable and Disable. If flow control is set Enable, both parties can send PAUSE frame to the transmitting device(s) if the receiving port is too busy to handle. When it is set Disable, there will be no flow control in the port. It drops the packet if too much to handle.
Default: Enable.
Wait State:
For more details about this parameter please refer to section
Default: Disable.
51
