Operator panel overlay
4 Attach the operator panel overlay.
If English is not your preferred language, attach the overlay with the appropriately translated names for the operator panel.
aPeel the protective backing off the over- lay.
bAlign the holes in the overlay with the buttons on the operator panel and press it into place.
cRub the overlay firmly to make sure it adheres securely to the operator panel.
dPeel the protective covering away from the overlay.
5 Attach the paper bail. If you will be installing a finisher or
aRemove the printer top cover and slide the plastic bracket onto the static brush holder. Adjust the bracket so it is cen- tered over the area where paper exits.
bPlace the tips of the wire paper bail into the ends of the plastic bracket so that the bail curves downward.
cReplace the top cover.
6 Attach output options. See:
•“Installing a finisher” on page 10
•“Installing an output expander” on page 11
•“Installing a
•“Installing a
9