Verifying the IP settings
Configure for Pull Printing (ImageQuick)
1 Print another network setup page and make sure the IP Address, Netmask, and Gateway are what you expected.
Use the information in “Printing a network setup page” on page 27 if you need help.
2 Ping the printer and verify that it responds.
For example, at a command prompt on a network computer type “ping” fol- lowed by the new printer IP address:
ping xxx.xxx.xxx.xx
If the printer is active on the network, you should receive a reply.
If your printer has an ImageQuick™ optional firmware card installed, you can con- figure for Pull Printing once an IP address has been assigned to your printer.
For detailed configuration instructions, refer to the online documentation on the ImageQuick CD. The ImageQuick CD is shipped with printers that have the ImageQuick optional firmware card
30
