Mounting bracket
Mounting slot
Slots 
Tabs
2 Slide the plastic bracket onto the static brush holder, located on the bottom of the output expander.
3 Insert the mounting brackets into the slots on top of the printer or output option. Make sure the output expander is seated securely.
4 Place the tips of the wire paper bail into the ends of the plastic bracket so that the bail curves downward.
The bail rests in the output tray of the expander below it, or in the printer output bin.
Note: Do not attach the paper bail unless you are mounting the output expander on the printer or another output expander.
5 Slide the lower tabs on the tray into the lower slots on the output expander.
6 Rotate the tray up until the upper tabs click into the upper slots.
7 Attach the top cover to the output expander.
12
