Handhold
Tab
Round peg
Setting up the printer In order to ensure adequate clearance when installing system board options, see “Install mem- ory and option cards” on page 17 before you posi- tion the printer if:
• You plan to install memory or option cards
and
• You will have less than 605.6 mm (24 in.) clearance on the left side of the printer.
CAUTION! Make sure your fingers are not under the printer when you set it down.
1 Ask someone to help you lift the printer by the handholds and lower it onto the duplex unit, optional drawer, table or printer cabinet.
The tab, round peg, and square holes on top of any drawer or the duplex unit help you seat the printer so the edges are aligned properly. Make sure the printer is securely in place.
Square hole
2 Remove the print cartridge packaging.
a Push the release latch and open the printer upper front door.
b Grasp the print cartridge by the hand grip and pull the print cartridge up and out.
Print cartridge
7