LG Electronics 42CQ610H FTG Mode via EBL Local Configuration, 22LQ630H, Jack Panel, 26/32LQ630H

FTG Mode via EBL (Local Configuration)

The following steps outline local FTG configuration of individual TV EBLs using a direct PC-to-TV connection. Refer to the Free-To-Guest (FTG) Device Configuration Application User Guide for further information.

Notes: • FTG Device Configuration Application software is available online at: www.LGsolutions.com/ ftgsoftware.

•If the TV CPU is already in FTG Mode, you cannot use this procedure to make changes to the FTG Channel Map and FTG Installer Menu settings. Instead, refer to and use the processes described on pages 43 to 45 to reconfigure the TV CPU.

•If the preceding condition applies, but you wish to switch the TV to FTG Mode via EBL, refer to Reference section, “Resetting Factory Defaults on the TV(s),” for further information before proceeding.

1. Install (if necessary) and launch the FTG Device	22LQ630H
Configuration Application (v5.0.0 or higher) on the	Jack Panel
PC that will be used to configure the EBL.	PILLOW SPEAKER		UPDATE
2. Build an FTG Channel Map using the FTG Channel
Map Editor in the FTG Channel Map Configuration		AUDIO IN SPEAKER
Utility (or, if applicable, open an existing FTG		(RGB/DVI) OUT(8Ω)
	RGB IN (PC)
Configuration [.rml] file).	/DVI IN	IN
		GAME CONTROLTV-LINK
		/ MPI	CFG

Note: Up to 141 logical channels can be defined in		.......... ..........
	1	2
the FTG Channel Map.

TV-LINK CFG

Laptop

PC

3.Connect the PC to the TV-LINK CFG jack on the TV’s rear connections panel using a USB-to-TTL serial cable (TTL-232R-5V-AJ). If necessary, install the device driver on the PC.

4.Turn ON the TV.

Note: If Installer Menu item 118 POWER SAVINGS is set to 3 (default), the TV must be ON in order for steps 5 and 6 below to be successful.

5.“Write” the FTG Channel Map to the EBL (switches the EBL from Pass-through Mode to FTG Mode).

Note: After a “Write” of new data, the TV will briefly display a green text banner that shows the EBL firmware version and release date.

USB-to-TTL Serial Cable

26/32LQ630H		TV-LINK CFG
Jack Panel
ANTENNA IN	TV-LINK
PTCSERVICE CPUSERVICE
(SERVICEONLY)(SERVICEONLY)	CFG	Laptop
		PC

USB-to-TTL Serial Cable

6.“Read” the current FTG Installer Menu settings from the EBL using the FTG Installer Menu Configuration Utility. If necessary to make changes to Installer Menu items, “Write” them back to the EBL in FTG Mode.

7.Save the FTG Channel Map and FTG Installer Menu settings to an FTG Configuration (.rml) file for future use.

8.Tune the TV to a logical channel in the FTG Channel Map.

42CQ610H Jack Panel

RESET UPDATE

		TV-LINK CFG
PTC SERVICE	SPEAKER OUT
(SERVICEONLY)	8Ω
	TV-LINK	Laptop
	CFG

PC

RS-232C IN

AUDIO IN (SERVICE ONLY) (RGB/DVI)

USB-to-TTL Serial Cable

48 206-4207