LG Electronics 22LQ630H, 26LQ630H, 32LQ630H, 42CQ610H Note:, OK (Enter), OK (Enter), OK (Enter), OK (Enter), OK (Enter), TEACH TO TV, 117 FACT DEFAULT, Exit Express Script, Exit Express Script

Clone Programmer Cloning Procedures (Cont.)

(Optional) Set the Clock

Set the time on a Master TV’s clock. (If the time has already been copied from a TV into the TLL-1100A clone programmer, you can set the Master TV’s clock by copying the time from the clone programmer.) The TLL-1100A can copy the current time to both a Master TV and to the clone’s internal clock—accurate to within one minute.

Since the TLL-1100A’s time cannot be set directly, the current time needs to be copied from an LG TV equipped with an enabled MPI port.

After the time is copied to the TLL-1100A clone programmer, the current time will be maintained and can then be transferred to another TV. (This can be a Master TV or another TV which has already had the features set up.)

Teach Master TV Setup to Target TV

1.Turn ON the Target TV.

The next step depends on whether the Express Script Installer Menu Wizard appears on the screen when you turn ON the TV:

•If the Express Script is displayed, the TV is already in the required factory default state. Use the Up/Down arrow keys on the Installer Remote to select Exit Express Script, and press OK (Enter). Then, go to step 3.

•Otherwise, ensure the Target TV is in Pass-through Mode. Then, continue with step 2.

2.Use the Installer Remote to access the Target TV Installer Menu (see “Accessing the Installer Menu” on page 19 for further information). Set Installer Menu item 117 FACT DEFAULT to 1, and press OK (Enter). When the value changes back to 0, press OK (Enter) again to exit the Installer Menu.

Note: This step restores factory default settings on the TV, which will in turn re-activate the Express Script. Use the Up/Down arrow keys on the Installer Remote to select Exit Express Script, and press OK (Enter).

3.Tune/set the TV to an analog channel or Aux input (ideally the same source tuned for 2-5-5 + MENU Mode during the Custom Master TV Setup procedure, if applicable), and then connect the MPI cable to the MPI port on the Target TV. The Clone Selection Menu will display on the TV screen.

4.Ensure the correct Memory CBank(X) is selected on the TLL-1100A.

5.Press 2 on the Installer Remote to select TEACH TO TV from the Clone Selection Menu. Then, press OK (Enter) to transfer the Master TV Setup to the Target TV.

Teaching usually takes 3 to 4 minutes. “TEACHING IN PROGRESS” will be displayed on the screen during Teaching. When the Teaching process is complete, a “TEACHING COMPLETE” message will be displayed.

6.When Teaching is done, disconnect the MPI cable from the Target TV, and turn OFF the TV.

7.After a few seconds, turn ON the TV, and verify that the Master TV Setup is now resident on the Target TV.

CLONE SELECTION MENU

Selected Bank: CBankX Saved

(1)LEARN FROM TV

(2)TEACH TO TV

(3) SET CLONE CLOCK FROM TV

(4) SET TV CLOCK FROM CLONE

(5)DISPLAY TV SETUP

(6)DISPLAY CLONE SETUP

CLONE CLOCK = XX:XX

TV CLOCK = XX:XX

THE CLONE IS VERSION VX.X.X

-To change menu items, press channel keys or digits.

-To execute item, press Enter.