7.Key System Functions
7. Key System Functions
7.1 Call Park
A user can park using intercom call or CO line to CO line parking location.
7.1.1 Call Park
While connected to an outside call;
1)Press TRANS ( 
) button shorter than 1 second.
2)Dial a parking location.
3)The intercom call or CO line being used is on hold and the wireless terminal goes to an idle state.
7.1.2 Retrieving a parked call
1)Press TALK ( 
) or Accept ( 
) button.
2)Dial the parked location.
7.1.3 Parking Location Number
SYSTEM | PARKING LOCATION NUMBER |
601~608 | |
601~610 | |
601~619 |
7.2 Call Back
When you dial to a station that is busy or in DND mode, you can leave a call back indication message up to 5.
7.2.1 Call Back in case of Dialing to a Station in Busy State
1)After receiving intercom busy tone, press CALL BACK ( 
) button.
Note
If the busy station earlier goes to an idle state before pressing button, the called
station will have a message from the system. About the message, see the below “Answer a Message Waiting Indication”.
When the busy terminal is idle, a reserved user’s terminal for call back will be ringing.
1)Answer the ring by pressing TALK (
) button.
7.2.2 Call Back in case of Dialing to a Station in DND Mode or No Answer
1)If you receive intercom busy tone or there is no answer after dialing to a station, press
CALL BACK ( 
) button.
2)Then, if VMIB is installed in the system, a voice message is heard. Press “#” button to
leave a message. If you want to stop leaving a message, press END ( ) button. And if VMIB is not installed in the system, only a station message is left in the system for the called station.
3)A message icon is displayed in 3 minutes on the LCD of a reserved user’s station for call
back. |
|
|
|
4) If a call back message is displayed on the LCD, press TALK ( | ) or INT ( | ) | |
button shorter than 1 second and then press CALL BACK ( | ) button to make a call | ||
to a station leaving a message. |
|
|
|
47
