Architecture Grille Aluminum - Single | Note: |
Pack | A baffle kit must not be used with a stamped aluminum grille |
Part No: AYAGALA01 | on any PTAC installation. |
| |
Stamped Aluminum Grille | Stamped Aluminum Grille |
Architecture Grille
Description
Outdoor grilles are attached to the wall sleeve and exposed to the exterior wall. The grilles are an industry standard size of 42" x 16".
Receiving
Upon receipt of the product, inspect the shipping carton for signs of visible damage. Report any damage or shortage to the carrier and note it on the delivery receipt. The unit must be stored in its original shipping carton in a dry, secure place prior to its installation and use.
Installation
The installation and servicing of the equipment referred to in this booklet should be performed by qualified, experienced technicians.
WARNING
Hazardous Voltage!
Disconnect all electric power, including remote disconnects before servicing. Follow proper lockout/tagout procedures to ensure the power can not be inadvertently energized. Failure to disconnect power before servicing could result in death or serious injury.
Important Note:
The unit OFF switch does not disconnect all electrical power to this unit.
1.Prepare the wall sleeve for installation of the grille by removing the cardboard stiffener and rear enclosure panel from the sleeve. These items may be removed from inside of the building.
Note:
The sleeve stiffener must be taken out before the rear sleeve enclosure panel can be removed from the sleeve.
2. Prepare the stamped aluminum grille for installation on the sleeve by inserting the six (6) plastic grommets into the square holes located near the outer edges of all four sides of the grille. With the grille positioned so the flanges of all four sides are in the up position, insert the grommets so the square end protrudes through the grille in the opposite direction from the flanges.
3.Turn the grille so it can be removed through the rear sleeve opening.
4.Install the stamped aluminum grille by aligning the guide pins located in the lower right and left hand corners of the grille with the corresponding holes in the rear of the wall sleeve.
5.Secure the grille by threading each of the screws into the plastic grommets.
6.Remove the wire handle (not shown in the picture) from the center of the grille prior to installing the chassis into the sleeve.
Note:
Be sure to keep a firm grip on wire handle and grille to prevent it from dropping and/or causing possible injury or property damage.
Architectural Grille
1.Remove the cardboard sleeve stiffener and the rear enclosure of the sleeve as described in Step 1 of the stamped aluminum grille instructions.
2.Turn the grille so it can be removed through the rear sleeve opening.
3.Install the grille by aligning the four screws supplied to their corresonding holes in the architectural grille.
Copyright ©2008 LG Electronics. Inc. All right reserved. | - 28 - |
Only for training and service purposes | LGE Internal Use Only |
|
