Remote Escutcheon Kit
Part No: AYRE110
Description
This kit provides an attractive replacement escutcheon (see Figure 53). The kit allows the removal of control knobs and graphics, which are not required when a wall thermostat is used to control the unit.
Receiving
Upon receipt of the product, inspect the shipping carton for signs of visible damage. Report any damage or shortage to the carrier and note it on the delivery receipt. The unit must be stored in its original shipping carton in a dry, secure place prior to its installation and use.
Installation
The installation and servicing of the equipment referred to in this booklet should be performed by qualified, experienced technicians.
WARNING
Hazardous Voltage!
Disconnect all electric power, including remote disconnects before servicing. Follow proper lockout/ tagout procedures to ensure the power can not be inadvertently energized. Failure to disconnect power before servicing could result in death or serious injury.
Important Note:
The unit OFF switch does not disconnect all electrical power to this unit.
Figure 53—Standard Escutcheon
Figure 54
1.Grasp the cabinet front as shown in Figure 54.
2.Pull the bottom of the cabinet front away from the chassis until the retaining clips disengage as in
Figure 55.
3.Lift the cabinet front off the chassis.
4.Lifting the front edge of the escutcheon, slide the tabs at the top of the escutcheon out of the retaining holes and remove the escutcheon. See Figure 56.
Figure 55
Copyright ©2008 LG Electronics. Inc. All right reserved. | - 35 - |
Only for training and service purposes | LGE Internal Use Only |
|
