USING YOUR REFRIGERATOR
Light up the crushed ice lamp by pressing the selection button. The icon will be illuminated.
To dispense water or ice, gently push your cup against the dispenser pad.
NOTE: Hold your cup in place for a couple of seconds after dispensing ice or water so the last few drops go in your cup instead of on the floor.
freezer, start by adjusting the refrigerator and allow 24 hours for the temperature to stabilize. If it is too warm or too cold, then adjust the freezer control. Use the settings listed in the chart below as a guide. Always remember to wait at least 24 hours between adjustments.
CONDITION/REASON: RECOMMENDED ADJUSTMENT:
DOOR ALARM
When either refrigerator or freezer door is left open for more than 60 seconds, an alarm will sound 5 times at
REFRIGERATOR section is too warm
•Opening the door often
•Adding a large amount of food
•Room temperature is very warm
Adjust the REFRIGERATOR setting to the next highest number and wait 24 hours, then check.
closing the door.
FILTER
(Filter Replacement Cycle)
There is an indicator light for the water filter cartridge on the dispenser that will blink to indicate it is time to change the water filter. Water filters usually need to be replaced once every six months. After replacing the filter, press and hold the Filter Reset button for 3 seconds to turn off the filter status light.
FREEZER section is too warm/ ice is made too slowly
•Opening the door often
•Adding a large amount of food
•Room temperature is very low (not cycling often enough)
•Using ice frequently
•Air vents blocked by objects
Adjust the FREEZER setting to the next highest number and wait 24 hours, then check.
Remove any objects blocking air flow.
LOCK
The Lock button deactivates the temperature controls and dispenser functions.
Press and hold this button for 3 seconds or until the Lock indicator light is lit.
To disable the Lock function, press and hold the filter button for seconds or until the Lock indicator light is off.
ICE PLUS
Press this button once to activate the increased ice making function. The ICE PLUS icon on the display panel will illuminate when activated. The Ice Plus function runs the freezer compartment at the coldest settings for a 24 hour period to increase ice making. Press the button again to cancel the Ice Plus function.
ADJUSTING CONTROL SETTINGS
Give the refrigerator time to cool down completely before making final adjustments. It is best to wait 24 hours before doing this. The initial settings mentioned in “Control Panel Features” section should be correct for normal household refrigerator use.
The refrigerator control functions as the thermostat for the entire appliance (refrigerator and freezer sections). The colder the setting, compressor will the longer the run to keep the temperature colder. The freezer control adjusts the cold air flow from the freezer to the refrigerator. Setting the freezer control to a lower temperature keeps more cold air in the freezer compartment to make it colder.
If you need to adjust temperatures in the refrigerator or
REFRIGERATOR section | Adjust the |
is too cold | REFRIGERATOR setting |
• Controls not set | to the next lowest |
correctly for your | number and wait 24 |
conditions | hours, then check. |
FREEZER section is too | Adjust the FREEZER |
cold | setting to the next lowest |
• Controls not set | number and wait 24 |
correctly for your | hours, then check. |
conditions |
|
ICE MAKER OPERATION
WARNING
PERSONAL INJURY HAZARD
Avoid contact with the moving parts of the ejector mechanism, or with the heating element that releases the cubes. DO NOT place fingers or hands on the automatic ice making mechanism while the refrigerator is plugged in.
A
Power Switch
ON / OFF
Feeler Arm
14