REFRIGERATOR INSTALLATION
Figure 1
(2 )
(1 ) |
|
|
(4) | (3) | (5) |
|
| (7) |
(5) |
| (6) |
(6) (7) |
| Rivet |
Type 1 |
| Type 2 |
CAUTION: When lifting the hinge free of the latch, be careful that the door does not fall forward.
6.Lift the door from the lower hinge pin being careful to pull the water lines through the lower hinge pin.
7.Place the door, inside facing up, on a non scratching surface.
Reinstalling the right (refrigerator) door:
1.Place the door onto the lower hinge pin.
2.Fit top hinge (4) over hinge lever latch (5) into place. Rotate lever (3) counterclockwise to secure hinge.
NOTE: Regardless of hinge lever type, reinstallation process is the same.
3.Hook tab on switch side of corner under edge of wire opening in cabinet top. Position cover (2) into place. Insert and tighten cover screw (1).
(1)
(2 )
(3) (4) | (3) Rivet |
| (5) |
| (4 ) (5 ) |
Type 1 | Type 2 |
|
Reinstalling the left (freezer) door:
(2 ) |
| |
(1 ) |
| |
(4) | (3) | |
(7) | ||
| ||
(5) | (5) | |
(6) | (6) | |
(7) | Rivet | |
| ||
Type 1 | Type 2 |
1.Feed the water tubes through the lower hinge pin and place the door onto the lower hinge pin.
2.Fit top hinge (6) over hinge lever latch (7) and into place. Rotate lever (5) clockwise to secure hinge.
NOTE: Regardless of hinge lever type, reinstallation process is the same.
3.Install the grounding screw (4) and connect all the wire harnesses (3).
4.Hook tab on door switch side of cover (2) under edge of wire opening in cabinet top. Position cover into place. Insert and tighten cover screw (1).
5.Reconnect the water tubes by inserting the tubes into the connectors.
Collet
Tube
Insert Line
DOOR ALIGNMENT
Remove the base grille before adjusting the doors. See “Base Grille Installation” for reference. Two methods of door alignment are available based on the amount of adjustment needed and installation requirements.
Type 1
Adjusting tool: Flat blade screwdriver. If the freezer compartment door is lower than the refrigerator compartment door, level them by inserting a flat blade screwdriver into the groove of the left leveling leg and rotating it clockwise.
Height difference
Left | Height |
leveling leg | difference |
|
If the freezer compartment door is higher than the refrigerator compartment door, level them by inserting a flat blade screwdriver into the groove of the right leveling leg and rotating it clockwise.
Height difference
Right
Heightleveling leg difference
8