REFRIGERATOR INSTALLATION
WARNING
EXCESSIVE WEIGHT HAZARD
Use the assistance of two or more persons to move or install the refrigerator. Not following these instructions may cause injury to the back and other parts of the body.
UNPACKING YOUR REFRIGERATOR
Before installing your refrigerator, remove any tape or temporary stickers. Do not remove any stickers that feature warnings, the model serial number or the technical label of the product located on the back of the refrigerator.
To remove adhesive tape residue, rub it well with your fingers and a little liquid detergent. Clean with warm water and let dry.
is between 41 °F (5 °C) and 110 °F (43 °C). If the temperature around the appliance is too low or high, cooling ability may be adversely affected.
NOTE: For proper air circulation, and best cooling and energy consumption results, maintain a minimum distance of 2 inches (5,08 cm) from adjacent items and surfaces.
2"(5,08 cm) 
WARNING
Be careful when you work with the hinge, base grille, stopper, etc. You may be injured.
Do not put hands or metal sticks into air vents, base grille or bottom of the refrigerator. You may be injured or receive an electrical shock.
Do not use sharp instruments, rubbing alcohol, flammable liquids or abrasive cleaning products to remove the adhesive tape or glue. These products can damage the surface of your refrigerator. For more information, see the section on “Important Safety Instructions”.
The shelves come already installed in their factory position. Remove the shelves and replace them according to your spacing needs.
WARNING
WHEN MOVING YOUR REFRIGERATOR
Your refrigerator is extremely heavy. Make sure you protect the floor when moving your refrigerator for cleaning or servicing. Always pull your refrigerator straight out when moving it. Do not shift from side to side or “walk” the refrigerator when attempting to move it as this can cause damage to the floor.
WARNING
EXPLOSION HAZARD
Keep all flammable materials and vapors (such as gasoline) away from the refrigerator. Not following these instructions may cause death, explosion or fire
INSTALLATION
1.Avoid placing the unit near heat sources, direct sunlight or humidity.
2.To minimize noise and vibration, the refrigerator MUST be installed on a solidly constructed floor.
3.Carpeting and soft tile surfaces are not recommended.
4.NEVER install the refrigerator on a platform or a weakly supported structure.
5.Install this appliance in an area where the temperature
BASE GRILLE INSTALLATION
To install or replace base grille:
1.Remove the 2 screws from the bottom front part of refrigerator.
2.Place base grille into position and insert and tighten screws.
To remove the base grille:
1.Open the doors (Refrigerator and Freezer).
2.Once doors are open, remove screws from base grille and remove.
3.Reattach screws to the base of refrigerator.
6
