Liebert GXT3-10000T220 user manual Inspection, Required Setup Equipment, Unpacking

Unpacking the UPS and Site Preparation

2.0UNPACKING THE UPS AND SITE PREPARATION

2.1Inspection

Upon receiving your Liebert® GXT3-10000T220™, examine the packaging for any signs of mishandling or damage. While removing shipping materials, inspect the UPS for damage. If any damage is noted, notify your local Liebert representative and your carrier.

2.2Required Setup Equipment

The following tools are required to set up your Liebert GXT3-10000T220:

•pallet jack

•utility knife or scissors

•screwdrivers—Phillips and straight blade

2.3Unpacking

Exercise care when removing the packaging to avoid damaging the UPS. Check all packaging to ensure that no items are discarded. Remove the packaging following the sequence in Figure 3.

! WARNING

The UPS is heavy and will roll when on an incline. When removing the unit from its shipping pallet, use at least two persons.

1.Using a pallet jack, move the Liebert GXT3-10000T220 near its installation site.

2.Unlock all the snaps securing the shipping case to the shipping pallet.

3.Lift the shipping case off the UPS.

4.Remove the EPE packing cushions from around the Liebert GXT3-10000T220.

5.Remove the ramp from the front and slip into the slot on the front of the shipping pallet.

6.Roll the UPS off the shipping pallet.

Figure 3 Unpacking

Plywood

Case

Packing Cushion

(EPE)

GXT3 T220

UPS

Ramp in slot

on shipping pallet

Unlock

Ramp

Storage

If the UPS will be stored, it must be placed indoors in a clean, dry area. Protect all the equipment, including its batteries, from extreme temperatures, high humidity, spills and other damaging conditions. Refer to Table 9 for permissible environmental conditions for storage.

Handling

The equipment must be kept upright at all times and handled with care. It may be damaged if dropped or subjected to severe impact.

6