Liebherr 7084284-03 Defrosting with NoFrost, Cleaning the appliance, Cleaning the IceMaker

Maintenance

u Pay attention that the defrost water does not run into the kitchen unit.

u If necessary, pick up defrost water several times, using a sponge or cloth.

u Clean the appliance (see 6.3) and rub dry.

6.2 Defrosting with NoFrost*

The NoFrost system automatically defrosts the appliance.

Refrigerator compartment:

The defrost water evaporates due to the compressor heat. Drops of water on the rear wall are perfectly normal.

u Regularly clean the drain opening to allow the water to flow away (see 6.3) .

Freezer compartment:

The moisture condenses on the evaporator, is periodically defrosted and evaporates.

u The appliance does not have to be manually defrosted.

6.3 Cleaning the appliance

CAUTION

Risk of injury and damage as a result of hot steam! Hot steam may damage the surfaces and cause burns. u Do not use any steam cleaners!

NOTICE

Incorrect cleaning damages the appliance!

u Do not use cleaning agents in concentrated form.

u Do not use any scouring or abrasive sponges or steel wool. u Please do not use any aggressive, scouring, sand-,

chloride-, chemical- or acid-based cleaning agents. u Do not use chemical solvents.

u Do not damage or remove the type plate on the inside of the appliance. It is important for the customer service.

u Do not pull off, bend or damage cables or other compo- nents.

u Do not allow any cleaning water to enter the drain channel, ventilation grille or electrical parts.

u Please use soft cleaning cloths and a universal pH-neutral cleaning agent.

u Please use cleaning and care products suitable for contact with foodstuffs in the appliance interior.

u Empty appliance.

u Pull out the power plug.

u Clean plastic outer and inner surfaces with lukewarm water and a little washing-up liquid.

u Clean drain hole: Remove deposits with a narrow instrument, e.g. a cotton bud.

u Clean items of equipment by hand with lukewarm water and a little washing-up liquid.

u Remove the support rails for the half glass shelves for cleaning.

u To dismantle the shelves: remove trims and side parts.

*

u To dismantle door racks: Pull off protective film from the decorative trims.*

u Dismantle door racks as illus- trated.*

*

After cleaning:

u Wipe dry the appliance and items of equipment. u Connect the appliance and switch it on again. u Switch on SuperFrost (see 5.6.4) .

When the temperature is sufficiently cold: u Put the food back inside.

6.4 Cleaning the IceMaker*

Fig. 30

The IceMaker has to be switched on.

u Pull out the drawer and remove the ice cubes.

u Clean the drawer with warm water and mild washing-up liquid.

u When the drawer is pulled out, hold down the On/Off button (about 10 seconds).

w After about 1 s the LED goes out, the IceMaker is switched off.

w After about 10 s the LED flashes for about 60 s. u Slide in the drawer while the LED is flashing.

w The ice-cube tray of the IceMaker turns to a skew position. u Remove the drawer.

u Clean the ice cube tray with warm water. If necessary, use mild washing-up liquid. Then rinse.

Switch the IceMaker on again.

u Press the ON/OFF button until the LED shines, then slide in the drawer.

w The IceMaker starts producing ice cubes. If washing-up liquid was used:

u throw away the first three loads of ice cubes to get rid of any remaining washing-up liquid.

6.5 Replacing the interior light*

Bulb data q max. 25 W

q Bulb fitting: E14

q Current type and voltage must conform with the data on the type plate

uSwitch off the appliance.

uPull out the mains plug or switch off/unscrew the fuse.

uTake hold of the lamp cover at the top and bottom Fig. 31 (1).

uDisengage the lamp cover at the back and detach it Fig. 31 (2).

uReplace the bulb Fig. 31 (3).

Apply slight pressure when turning the bulb to overcome the friction of the seal. Pay attention that the seal is seated properly in the lamp socket.

Fig. 31

15