Life Fitness 8500 3 manual Button Head

		82	32
				84	85
33			87 3/8 X 1-1/4”
			BUTTON
			HEAD
65					23
62	41		34
					1/2 X 4” 96
		79
FIGURE 17

STEP 17:

•SECURELY assemble two 3/8 X 2-3/4” SPRING PINS (62) to the PAD SLEEVES (33) as shown in FIGURE 17.

•Assemble four ROLLER PADS (41) to the PAD SLEEVES (33) using four 1-5/16” SHAFT COLLARS (79). SECURELY tighten set screws on SHAFT COLLARS (79). See FIGURE 16.

•Slide PAD SLEEVES (33) over LEG CURL/EXTENSION (32) until the spring pin pops into the holes. (NOTE: PAD SLEEVES should be facing as shown in FIGURE 17.)

•SECURELY assemble two 3/8 X 1” BUTTON HEAD CAP SCREWS (87) and two 3/8” LOCK NUTS (82) to the last holes in the LEG CURL/EXTENSION (32) as shown in FIGURE 17.

•Insert two 3 X 2” END CAPS (65) into the ends of the LEG CURL/EXTENSION (32) as shown in FIGURE 17.

•SECURELY assemble LEG FRAME (34) to the LEG WEIGHT STACK BASE (23) using two 1/2 X 4” BOLTS (96), two 1/2” WASHERS (84), and two 1/2” LOCK NUTS (85). See FIGURE 17.

STEP 18:

109

• Snap two WEIGHT PLATE BUSHINGS (109) into the top side of all

sixty WEIGHT PLATES (106) as shown in FIGURE 18. 106

FIGURE 18

1/2

1/2

1/2

1/2

1/2

1/2

0

1 2 3 4 5

18

6