Life Fitness 8500 3 manual Press CABLE38

	FIGURE 34
	82
36	69
	116	82
	69
	58
90 3/8 X 2-3/4”
	80
		44
92 3/8 X 4”
	48
	38
92 3/8 X 4”

STEP 34:

•Route the threaded end of the PRESS CABLE (44) around one 4-1/2” PULLEY

(48)and SECURELY assemble the pulley to the front slot of the PRESS ARM AD- JUST (36) using one 3/8 X 2-3/4” BOLT (90), two 3/8” FLANGE SPACERS (69), and one 3/8” LOCK NUT (82) as shown in FIGURE 34. (NOTE: Loop the cable over the pulley prior to inserting it into the slot.)

•Route PRESS CABLE (44) through the slot in the PRESS BASE (38) thenSECURELY as- semble one 4-1/2” PULLEY (48) to the PRESS BASE (38) using two 3/8 X 4” BOLTS (92), two 2-7/8 X 2-1/4” CABLE CLIPS (116), two 3/8” FLANGE SPACERS (69), two 3/8 X 1/2” SPACERS (58), two 3/ 8” WASHERS (80), and two 3/8” LOCK NUTS (82) as shown in FIGURE 34.

(NOTE:Make sure the cable is routed be- tween the pulley and the CABLE RETAIN- ING BOLT.)

•Route the PRESS CABLE (44) around one 4-1/2” PULLEY (48) and SECURELY as- semble the pulley to the rear slot of the PRESS ARM ADJUST (36) using one 3/8 X 2-3/4” BOLT (90), two 3/8” FLANGE SPACERS (69), and one 3/8” LOCK NUT

(82)as shown in FIGURE 34. (NOTE:

Loop the cable over the pulley prior to inserting it into the slot.)

STEP 35:

• SECURE the PRESS CABLE (44) and two 4-1/2” PULLEYS (48) to the vertical flats on the PRESS BASE

(38)and on the PRESS WEIGHT STACK BASE (24) using two 3/8 X 2” BOLTS (89), two 2-7/8” CABLE

CLIPS (67) two 3/8” WASHERS (80), and two 3/8” LOCK NUTS (82) as shown in FIGURE 35. (NOTE:

The PRESS CABLE (44) should be routed underneath the short leg of the CABLE CLIP. Also, the CABLE CLIPS should be positioned straight down to function properly.)

89 3/8 X 2”

24

80

82

44 PRESS	48
	67

CABLE38

FIGURE 35

1/2

1/2

1/2

1/2

1/2

1/2

0

1 2 3 4 5

28

6