6.2 TROUBLESHOOTING
PROBLEM |
| CAUSE / SOLUTION | |
|
| ||
| Check to see that the power cord is fully plugged into the back of the | ||
| product and into the wall. Make sure the power cord is fully seated into | ||
| the back of the product. | ||
|
| ||
No power | You may be in “Energy Saver Mode”. Press the “Energy Saver” button to | ||
see if the console turns on. | |||
| |||
|
| ||
| Verify that all customer assembly connections are working properly. | ||
| Unplug and | ||
| were pinched during assembly. | ||
|
| ||
| Potential reasons for the wireless heart rate not to work properly include: | ||
| 1. The wireless heart rate is turned OFF in the Settings Menu. Enter | ||
|
| the Settings Menu and verify that WIRELESS HR is turned ON. | |
| 2. There is poor contact between the telemetry heart rate strap and | ||
Wireless Heart Rate is Not |
| the skin. | |
3. | There is electrical interference from electrical appliances with the | ||
Working | |||
| telemetry heart rate strap from fluorescent lights, kitchen appliances, | ||
|
| ||
|
| etc. Move the product to a different location or move electrical | |
|
| appliances away from the product. | |
| 4. | The battery in the Heart Rate Telemetry Strap needs to be replaced. | |
|
| The battery is a CR2032 (3V). | |
|
| ||
| Use of personal electronic devices, such as cell phones and portable | ||
| mp3 players, cause external noise interference. | ||
Heart rate reading is initially | Equipment is in close proximity to other sources of noise such as audio/ | ||
detected and functioning | |||
video equipment, fans, two way radios, and high voltage/high current | |||
normally but then is lost | |||
power line. | |||
| |||
| Remove the source of noise or reposition the exercise equipment. | ||
|
| ||
| Be sure to grasp the sensors firmly and keep hands still. If heart rate | ||
| seems substantially higher or lower than expected, remove hands from | ||
| sensors until heart rate disappears. | ||
|
| ||
| Tips for contact heart rate: | ||
Contact heart rate sensors are | 1. Dry hands to prevent slipping on the sensors. | ||
not reading my heart rate | 2. Apply hands to all four sensors (two in each hand). | ||
correctly | 3. Grasp sensors firmly. | ||
| 4. Apply constant pressure to the sensors. | ||
| 5. May need to wait longer for heart rate to display. | ||
|
| ||
| Note: The heart rate hand pulse sensors provide an approximate heart | ||
| rate value. The sensors are not medical devices and should not be used | ||
| in any type of medical application. | ||
|
|
| |
27
