LifeSpan TR4000I manual Handlebar Assembly

TR3000i / TR4000i

Folding Treadmill

Step 3: Handlebar Assembly

A.Rotate the handlebars down so they are positioned on top of the handlebar posts. Secure the right and left handlebars to the support post using the 2 M8 x70L screws (B) provided in the hardware bag. If it is difficult to start the bolt at this time, look to make sure there are no wires obstructing the bolt hole. Also, lightly pulling the handlebar one way or the other will help line up the bolt holes.

Note: Make sure that the wires on both sides are not pinched in-between the handlebars and the handlebar post.

B.Rotate the console bracket (8) up in the back until it reaches its normal operating position.

C.Place the left outside handlebar cover (9) next to the inside handlebar cover (pre-attached).

allowing the plastic ridge to sit in the groove of the blue rubber ring. Secure these three parts together using the self-tapping screws (C), which are pre-installed in the outer cover. Repeat this process on the other side with the right outside handlebar cover (10).

10 8

B

9

C

blue rubber ring

X

11