Lincoln Electric 11521 service manual Accessories

C-4 ACCESSORIES C-4

Return to Master TOC

MAKING A WELD WITH THE SPOOL GUN ADAPTER KIT AND SPOOL GUN INSTALLED

CAUTION

In either toggle switch position, closing either gun trigger will cause the electrode of both guns to be electrically “HOT”. Be sure unused gun is posi- tioned so electrode or tip will not contact metal case or other metal common to work.

-----------------------------------------------------------------------

1.Setting spool gun selector switch to the “Normal” position and pulling the trigger for the built-in feed- er gun.

4.Refer to the procedure decal on the Power MIG® for initial aluminum settings. Make a test weld to determine the final settings.

5.To return to normal POWER MIG® 215XT welding, release the spool gun trigger set spool gun selector switch to normal and reset feeder gun voltage pro- cedure setting if necessary.

Return to Section TOC

Return to Section TOC

Return to Section TOC

Return to Section TOC

Return to Master TOC

Return to Master TOC

Return to Master TOC

•Disables spool gun operation and spool gun gas solenoid valve.

•Closing feeder gun trigger starts feeder gun welding and makes both electrodes electrically “HOT”.

2.Setting spool gun selector switch to the Spool Gun Position, select either spool gun and pulling SPOOL GUN Trigger.

•Disables built-in feeder gun operation and machine gas solenoid valve.

•Enables spool gun operation and spool gun gas solenoid valve.

•Closing spool gun trigger starts spool gun weld- ing and makes both electrodes electrically “HOT”.

3.Operation with POWER MIG® 215XT:

•Turn the POWER MIG® 215XT input power ON.

•Adjusting the voltage tap control will increase or decrease your welding voltage.

•Adjusting the wire speed control on the spool gun will increase or decrease the spool gun wire feed speed.

NOTE: Adjusting the wire feed speed control on the Power MIG® Panel has no affect on the spool gun’s wire feed speed.

Power MIG® 215XT