![](/images/new-backgrounds/1195387/19538713x1.webp)
Instant EtherFast® Series
Chapter 4: Windows Driver Setup
Overview
This section installs the PrintServer’s software on your Windows 95, 98, Millennium, NT, 2000, or XP computers to give them PrintServer printing abil- ities. The PrintServer is fully compatible with Windows 95, 98, Millennium, NT 4.0, 2000, and XP environments.
At this point, you must have:
•the PrintServer hardware installed on your network. If not, see Chapter 3: Hardware Installation.
•TCP/IP installed on each of your computers.
•an IP address assigned to each of the computers on your network. If not, see Chapter 9: DHCP Support for the
•an IP address assigned to the PrintServer. By default the PrintServer has DHCP enabled. If you need to assign an IP address, go to Chapter 5: Bi- Admin: PrintServer Management.
This setup should be completed on the network administrator’s computer before all other users’ computers on the network. The PrintServer’s IP address will be assigned in this first installation on the network administrator’s com- puter only, which takes three extra steps.
It is assumed that your
If you need to install the PrintServer’s driver on computers without a
EtherFast®
The Autorun Bi-Admin Management Utility Installation
1.Insert the Setup Utility CD. A
Figure
2.The installation routine will begin to run and display Figure
Figure
7 | 8 |