Setting the remote control using code entry

Operating additional equipment

Operating other Loewe devices with the RC3 remote control

Using this remote control, you can operate additional devices from Loewe.

DVD	STB Use the rotary switch to select VCR, TV or a Set Top Box.
	TV
VCR	The following are preset at the factory: Loewe VCRs, Loewe TV
	sets and for STBs (Set Top Box) in Germany, the
	common d-box.

Use the driver buttons in the TV and STB position for VCR, DVD or Digital Recorder.

DVD STB

VCR

END

EPG

jkl

def

wxyz

Use the rotary switch if you want to switch over a VCR, DVD device or a Set Top Box.

Press the END and EPG buttons simultaneously for at least 5 seconds. The upper left indicator on the remote control will blink twice.

Enter the four numbers in sequence that you found in the code list (e.g. 0539 for Loewe DVD player).

You can switch over the six drive buttons

( , , , , , ), both for the TV and for the STB, to control a VCR or DVD player/recorder (the control of the integrated “Digital Recorder Plus” is preset at the factory):

After each number you enter, the indicator will blink once, after the last number it will blink twice. If the number was incorrect, the indicator will remain lit longer. The code number was not accepted. If the code was accepted with two blinks, you can test the functions of the device you just programmed.

DVD STB

VCR

END

EPG

wxyz

tuv

First set the switch to the main function TV or STB.

Then press the END and EPG buttons simultaneously for at least 5 seconds. The upper left indicator on the remote control will blink twice.

Enter the the numbers 988 in sequence. The indicator will again blink two times.

If the device cannot be operated or can only be operated poorly, repeat the code entry with the next code from the list. If there are no other codes speciﬁed for this manufacturer, try it using the code suggestions from the remote control.

Setting the remote control using the suggestions from the remote control

Switch the device on that you want to switch over to the remote control. Standby mode is not enough.

tuv

DVD STB

VCR

PIP

Now set the switch to the desired function for the drive buttons:

to DVD, VCR or to TV, if the digital recorder is to be operated.

Press the # PIP button to complete the setting. The indicator will blink two times.

DVD STB

VCR

END

EPG

wxyz

Use the rotary switch if you want to switch over a VCR, DVD device or a Set Top Box.

Press the END and EPG buttons simultaneously for at least 5 seconds. The upper left indicator on the remote control will blink twice.

Enter the the numbers 991 in sequence. The indicator will

Setting the remote control to operate devices from other manufacturers

You can switch over the remote control for other VCRs, DVD players and Set Top

wxyz

PIP

blink once after each number entered.

Press the # PIP button to select the ﬁrst code.

Boxes if the infrared code for the device type is listed in the code list or if it is included in the code memory of the RC3.

Even if the manufacturer of the device is listed in the code list, it may not be possible to operate that device using the Loewe remote control.