Loewe Spheros R 32 HD+ manual Initial installation, Installing the TV set, Connecting the TV set

Initial installation

Installing the TV set

First prepare the chosen installation solution for your TV set. See the installation instructions of the table stand supplied. See Accessories (page 55) for other installation possibilities.

Preparing the remote control unit

Inserting or replacing batteries

Press the embossed arrow and push down the battery compartment cover.

Insert two alkaline manganese LR 03 (AAA) batteries; ensure that the + and – poles are correctly positioned!

Slide the cover up from below.

LR03	AAA
AAA
LR03

Connecting the TV set

Connecting to the mains

Remove the cover for the connections.

Connect the TV set to a 220-240V outlet:

First plug the small plug of the mains cable into the mains connection on the rear of the TV, then plug the large plug into a mains power outlet.

Connecting the antenna

Analogue / DVB-C / DVB-T antenna:

Plug the antenna plug of antenna system, cable system, or room antenna into the ANT2 socket.

The connecting cable between ANT-TV– ANT OUT is plugged at the factory.

Satellite antenna:

Connect an antenna plug, e.g. from the antenna change- over switch or from the twin-LNC of the satellite system to the sockets ANT-SATand ANT-SAT2.

When connecting only one SAT antenna cable, connect

it to ANT-SAT.

ANT2

Adjusting the remote control for operating the TV set

Press the TV button.

See page 50 to learn about operating other Loewe devices.

ANT	ANT	220-240V~
SAT2	SAT
		50/60Hz
	TV
	R

Connections on the back of the set (see also page 5).

Replace the cover over the connections.

Receiving coded stations

When using a CA module and a Smart-Card to receive coded stations, please observe the handling of the CA module (see page 32).

- 10