Optional Equipment | 3 5 |
Optional Log (Part # 98900126)
!Make sure the heater has fully cooled before installation.
1 Assemble the log shelf following the directions below.
Left Log Shelf Leg
Right Log Shelf Leg
Nuts
Log Shelf Cross Brace
3/8" Nutdriver
2Remove the firepot from the pellet stove. Center the log shelf assembly (with extender attached) over the burnpot holder. Replace the burnpot. Place the log on the log shelf extender. When in place, the log should appear as shown in the photograph to the right.
bCenter the log on the log shelf and push it back so it rests against these two tabs.
aPlace the log shelf assembly so the back edge contacts the cast firebrick in the rear of the firebox. Note how the taper on the assembly matches the taper on the cast firebrick.
NOTE:
On inserts, the ash box must be installed before placing the log shelf assembly.
Optional Gold Door (part # 99300219)
Remove the door by sliding it up and off the door frame.
Slide the new door onto the door frame.
HINT: align the bottom joggle clips over the brackets on the door and slide into place. Then lift up slightly on the door to attach the upper clip.
The door is held in place with 4 joggle clips.
Door
Door
Frame
Travis Industries | 4 0 6 0 2 1 0 | 9 3 5 0 8 0 5 1 |
