Lopi 3 4Optional Equipment, Thermostat Part #, Travis Industries, 4 0 5 1 2 1, 9 3 5 0 8 0 5

3 4Optional Equipment

Thermostat (Part # 99300650)

!Do not connect 120 VAC to the thermostat circuit of this heater (do not use a household thermostat used for a wall-board or other electical heater).

1Attach the thermostat wire to the circuit board (see the illustration to the right). Route the wire through the back of the heater (away from any hot or moving components).

Attach the quick-connects to the two posts near the molex connector on the circuit board (orientation does not mater).

2Determine a location for the thermostat that is within range of the 20' length of thermostat wire. It should be centralized in the room and away from the heater. The wire may be routed externally on the wall or behind the wall (preferred).

3Follow the directions to the right to attach the thermostat and thermostat wires.

50 60 70 80 90

50 60 70 80 90

Robertshaw

Pull the cover off the thermostat

Run the thermostat wires through the wall (cut off excess wire, leaving 6” of slack).

Expose 1/2” of wire and attach to these two posts.

Standard

Screwdriver

Attach the thermostat to the wall through these two holes.

Travis Industries 4 0 5 1 2 1 6 9 3 5 0 8 0 5 1