Operation1 5
Loading Pellets
Lift the hopper lid to its vertical position. Pour pellets into the hopper until full. NOTE: The hopper holds approximately 35 pounds of pellets.
WARNING:
The front edge of the hopper lid becomes very hot, do not touch the area below the handle.
|
| e |
| ll | |
e |
| |
P |
|
|
NOTE: press the spring here while closing the hopper lid. Close the lid slowly to prevent pinching your finger.
ts 
Make sure pellets are not left on this heat shield.
The Two Modes of Operation:
Manual
Manual mode requires the user to turn the heater on and off manually.
Auto (requires a thermostat)
Auto mode allows you to use a thermostat to control room temperature. The stove automatically turns on when the temperature drops below the thermostat setting. Once the stove reaches operating temperature, the stove then runs at the heat output setting selected.
Switching Modes While in Operation
Whenever the stove is switched from one mode to another while in operation, the stove will enter the "start- up" sequence for a minimum of 20 minutes.
DISCONNECT POWER BEFORE SERVICE
H |
|
| |
E | HIGH | REMOTE | |
A | AUTO | ||
T |
| ||
|
| ||
O | MED | MANUAL | |
| |||
U |
|
| |
T |
| AUGER | |
P | LOW | ||
| |||
U |
| FAULT | |
T |
|
| |
|
| AUTO | |
H | UP | OFF |
EMANUAL
A
T DOWN MANUAL
UP START
F
AMANUAL
N
DOWN
AUGER
TM
TRAVIS INDUSTRIES
HOUSE OF FIRE
NOTE: if using a modulating remote, this light will come on to indicate the remote is controlling the heater.
These indicator lights are used to determine which mode you are in.
Use the mode switch to determine the mode.
Travis Industries | 4 0 5 1 2 1 6 | 9 3 5 0 8 0 5 1 |
