Connecting Motion / Alarm Device - Appendix #4
Connecting Motion / Alarm Device - Appendix #4
Motion detection and Alarm controls are enabled through the Menu system on the Observation System. Additional motion sensor devices can be connected to the system (Motion Sensors, Door/Window Sensors).
A motion detection or sensor unit can be used to send a signal to the Observation System to begin camera viewing on the matching Video Channel (when enabled in the Menu, see page 39):
•Example: A Window sensor unit has been installed on Alarm Block port #4. When this sensor is activated, the camera on DIN or BNC VIDEO port #4 will become active (if enabled in the MENU on the Observation System)
Installing a Sensor
1.Connect the GROUND Cable to the GND port on the Alarm Block on the Observation System.
2.Connect the SIGNAL Cable to a numbered port.
To start ALARM RECORDING on the System, configure the Alarm Settings in the System Menu.
OBSERVATION SYSTEM
SENSOR
(Not Included)
49