LOREX Technology L19WD Series Appendix 3 Setting Up Remote Viewing, What do you need?

Appendix 3: Setting Up Remote Viewing

Appendix 3: Setting Up Remote Viewing

You can control your system remotely using your existing network and the Lorex Client Software. Setting up the Remote Viewing feature demands several steps; networking skills are required to correctly setup the Remote Viewing functions.

What do you need?

•An integrated LCD-DVR system

•A PC with the installed Lorex Client 6.0 Software (refer to the Lorex Client Software Guide for installation instructions)

•A router (no included) connected to a High-Speed Cable or DSL modem (for remote viewing of your system over the Internet outside your home network)

SYSTEM

INTERNET

ROUTER PC

Network Setup / Remote Access Overview

To setup remote viewing:

1.With the system powered off, connect the system to the router using the included Ethernet cable.

2.Power the system on. You must connect the system to the router prior to turning on the system. This allows the system and router to communicate over the network.

3.Press and hold the Enter button on the front panel to find your system’s IP address.

4.Enable Port Forwarding on your router. Refer to the included Router Guide and Basics of Remote Video Access Guide for further assistance with your specific network setup and hardware.

5.Setup an account at www.lorexddns.net

56